[. . . ] Never put the machine in water or let the cord or plug get wet - you could get an electric shock. Always make sure there is water in the water reservoir before switching on. [. . . ] 3 Run two lots of water through the machine (without coffee) to clean it out. Each time pour one coffee tank of cold water filled to the "MAX" level into the water reservoir. See `to make coffee'. to make tea Follow the procedure for making coffee using tea leaves instead of filter coffee. Place the desired amount of loose tea into the permanent filter using the spoon provided. The amount will vary depending upon the type of tea used and individual tastes but as a guide use 4 - 6 spoons of loose tea per maximum capacity of water. For best results we recommend that only the required amount of tea is made at one time and that the tea is drunk within half an hour of brewing. ON OFF Auto ON OFF Prog H M CM450 series CM550 series You may notice fragments of tea leaves in the dispensed tea ­ this is normal. If alternating between tea and coffee making, take extra care to ensure the coffee tank and permanent filter are well washed and rinsed. You may wish to purchase an additional permanent filter and coffee tank to have dedicated parts for tea and coffee making. 5 Push the "Auto/ON/OFF" button once and "PRO" will show in the display indicating that the brew cycle will begin at the set time. Note: if the "Auto/ON/OFF" button is pushed twice, brewing will begin immediately. To check the programmed time, press the "Prog" button and the programmed time will flash. Press "Prog" button again to return back to the clock. service If the cord is damaged it must, for safety reasons, be replaced by Kenwood or an authorised Kenwood repairer. [. . . ] The digits will stop flashing and return to the set time 1 2 3 4 to descale 1 Buy a suitable descaler. 3 After descaling, run at least 2 lots of water through the machine to clean it out. [. . . ]